Well Pump Pulling And Installing Assist Tool - Pipe & Cable Roller For 4"+ Well Casings, No Power Needed

Pulling or installing a submersible well pump by hand is a tough, awkward job that can damage your drop pipe and wires. This simple but clever tool makes it much safer and easier. It clamps onto the top of your well casing (for casings larger than 4 inches) and has built-in polyurethane rollers. You feed your polyethylene pipe (poly pipe) and the pump wires through these rollers. As you pull up or lower down the pump, the rollers turn, guiding the pipe and wires smoothly over the sharp edge of the casing. This prevents them from getting scraped, cut, or pinched. It's made from strong, powder-coated steel, so it's durable and rust-resistant. The best part? It doesn't need any machinery or power – it's all manual, using your own strength, but it directs the force safely and protects your equipment. A must-have tool for well owners, DIY installers, or well service technicians. It can save you from a costly repair if you accidentally damage the pipe during a pump replacement. Just make sure your well casing is over 4 inches in diameter before ordering.